PC Access may display several messages pertaining to its copy protection. These types of messages are most common when you first install PC Access, or when you drastically change your computer setup (such as upgrading to a new hard disk without first uninstalling PC Access).
If you can't understand an error message and correct any underlying problem, you will need to call your PC Access technical support representative.
More:
Cannot continue without user authorization
Cannot run without valid registration information
Cannot uninstall user authorization
Cannot use key disk to register
Copy protection necessary for licensing
Could not allocate real mode memory buffer
Could not find copy protection
Incorrect file attributes on user authorization file
Installing PC Access User Authorization
Invalid reset registration code
Invalid reset user authorization code
Invalid source or destination drive ID
Serial number mismatch: diskette
User Authorization Error: Not Installed
User Authorization successfully installed
User Authorization successfully uninstalled
You can no longer run PC Access
You may now enter new registration information
Your authorization is now reset