 |
Technical Support | Contact Us |
PC Access for Windows Reference Guide
for PC Access Version 4.30
Modem Setup: Suggested Initialize Command
If the Modem Wizard cannot find any modem setups in the Windows Registry, and you cannot find your modem in the Modem Selection window, you should try the following Initialize Command. (The spaces between commands are optional and make no difference other than readability):
AT &C1 &D2 E1 Q0 V1 X4
These commands tell a Hayes-compatible modem to:
| &C1 (Ampersand C one) | Sets the modem to use the Data Carrier Detect (DCD) signal to tell PC Access when it is connected to a service. |
| &D2 (Ampersand D two) |
| Allow PC Access to hang up the connection by clearing (dropping) the Data Terminal Ready (DTR) signal. |
| E1 (E one) |
| Echo, to the computer, all characters the computer sends to the modem while the modem is processing commands. |
| Q0 (Q zero) |
| Send PC Access the results of each modem command. |
| V1 (V one) |
| Send the results in verbose form, i.e., as words. |
| X4 | Send extended result information to PC Access. |
This topic has changed for PC Access 4.30.