Installing the PC Access CD-ROM from your Hard Disk

Quick Contents

Introduction

Installing the PC Access CD-ROM from your Hard Disk

1. Insert your PC Access for Windows CD-ROM into your CD-ROM drive.
   • Windows 95/98 users:
     Click Start | Programs | MS-DOS Prompt.
   • Windows NT users:
     Click Start | Programs | Command Prompt.
2. At the MS-DOS Prompt window, type the following commands:

     CD  \
     MD  C:\PCADKTS
   

   This will create a temporary directory on your hard disk.
3. At the MS-DOS Prompt window, type the following commands:

     XCOPY  D:\DISKIMGS\DISK1\*.*  C:\PCADKTS
     XCOPY  D:\DISKIMGS\DISK2\*.*  C:\PCADKTS
     XCOPY  D:\DISKIMGS\DISK3\*.*  C:\PCADKTS
     XCOPY  D:\DISKIMGS\DISK4\*.*  C:\PCADKTS
     XCOPY  D:\DISKIMGS\DISK5\*.*  C:\PCADKTS
   

   • Note: The instructions above assumes that your CD-ROM drive is drive D:\
4. At the MS-DOS Prompt window, type:

     EXIT
     

   to close the MS-DOS Prompt and return to Windows.
5. To install PC Access from the PCADKTS directory on your hard disk, click Start | Run.
6. In the Run window, next to Open: type the following command:

   C:\PCADKTS\SETUP.EXE
   

7. Follow the instructions on your screen to install PC Access.
8. After the SETUP.EXE program installs PC Access, follow the instructions on your screen to install your User Authorization.
   • Note: When you finish installing PC Access from the disks you just created, PC Access will prompt you to install your User Authorization. You must use your factory original PC Access Disk 1.